Lab Assignments

Assignments & Instructions:

• It is essential to read the assignment before the lab and be ready to begin when you come to the lab.
• Report is due in a week.
   

Week	Project Description
Jan 16 - Jan 22	Lab 0: Introduction  Creating an Engineering Network Account
Jan 23 - Jan 29	Lab 1: Introduction to Altera DE board and Quartus II Design Software       Lab 1 Circuit      Lab steps     DE0 manual The only difference between DE0, DE1 and DE2 implementation is the FPGA number and PIN assignments. (Quartus II) software instructions remain the same.
Jan 30 - Feb 5	Lab 2: Schematic Entry, Timing Diagrams and Functional Simulation using Quartus II
Feb 6 - Feb 12	Lab 3: Design, Simulation and Verification of Combinational Circuits
Feb 13 - Feb 19	Lab 4: Two's Complement Adder Subtractor Design
Feb 20 - Feb 26	Lab 5: The Arithmatic Logic Unit
Feb 27 - Mar 8	Lab 6: The Seven Segment Display
Mar 9 - Mar 17	Spring Break
Mar 19 - Mar 25	Lab 7: BCD to Seven Segment Display
Mar 26 - Apr 1	Lab 8: Accumulator Based Tally Unit
Apr 2 - Apr 8	Lab 9: Register Bank and Shift Registers
Apr 9 - Apr 15	Lab 10: Design of Counters
Apr 16 - Apr 22	Lab 11: Encryption Unit
Apr 23 - Apr 29	Lab 12: Nanoprocessor

• The lab assignments use Altera DE boards and Quartus Prme software, available in C207 Engr.

Downloads:

• Quartus Prime software is available for download and installation on your computer (Download Quartus Prime 18.1).
• The following links will be helpful:
• Guide to install Quartus 18.1
• Installing device drivers for DE board
• Quartus Prime Troubleshooting
  
• Remote Access to Quartus Prime